1. Remove headrest and swing seatback forward.

2. Slide seat cover over top of seat and pull down.

3. Fit base of cover snugly over seat.

4. Fasten elastic under seat with supplied "S" hooks.

5. Tie the supplied cord in position to ensure that the seat cover is held in shape.

6. Ensure that seat cover is fitting perfectly.

7. With a sharp instrument (exacto knife, etc....), cut holes for your headrest.
Because the seat cover stretches slightly, the holes need not be too big. 
Also, cut the slits lengthwise with respect to your car (see Fig 7a). 
That way, normal entering and exiting the car will not damage the seat cover.

8. Re-insert the headrest into your seat.

*YOU WILL CUT THE SEAT COVER ON TOP TO ALLOW FOR HEADREST POSTS TO GO BACK THRU. 

Material will not fray! Just cut slit with blade on top of plastic cover piece for headrest posts.

Rear Bench Seats

1.  Fit section marked "back" to back rest.

2.  Remove the seat from the car, and then remove the back rest.

3.  Line up base pattern to the pattern on the back rest (if any).

4.  Secure all elastic straps with supplied "S" hooks.

5.  Replace rear back rest and rear base.

6.  Check that seat covers are secure, that seat covers

     are fitting correctly, and that all patterns match.